5G Technology World

  • 5G Technology and Engineering
  • FAQs
  • Apps
  • Devices
  • IoT
  • RF
  • Radar
  • Wireless Design
  • Learn
    • 5G Videos
    • Ebooks
    • EE Training Days
    • FAQs
    • Learning Center
    • Tech Toolboxes
    • Webinars/Digital Events
  • Handbooks
    • 2024
    • 2023
    • 2022
    • 2021
  • Resources
    • Design Guide Library
    • EE World Digital Issues
    • Engineering Diversity & Inclusion
    • Engineering Training Days
    • LEAP Awards
  • Advertise
  • Subscribe

Vanishing Friction

By Jennifer Chu, MIT News Office | June 4, 2015

Friction is all around us, working against the motion of tires on pavement, the scrawl of a pen across paper, and even the flow of proteins through the bloodstream. Whenever two surfaces come in contact, there is friction, except in very special cases where friction essentially vanishes — a phenomenon, known as “superlubricity,” in which surfaces simply slide over each other without resistance.

Now physicists at MIT have developed an experimental technique to simulate friction at the nanoscale. Using their technique, the researchers are able to directly observe individual atoms at the interface of two surfaces and manipulate their arrangement, tuning the amount of friction between the surfaces. By changing the spacing of atoms on one surface, they observed a point at which friction disappears.

A new technique tunes friction between two surfaces, to the point where friction can vanish. MIT researchers developed a frictional interface at the atomic level. The blue corrugated surface represents an optical lattice; the red balls represent ions; the springs between them represent Coulomb forces between ions. By tuning the spacing of the ion crystal surface above to mismatch the bottom corrugated surface, friction disappears. The ions smoothly slide along the surface in a caterpillar-like motion. This discovery could aid in developing nanomachines, built from components the size of single molecules.  (Illustration: Christine Daniloff/MIT)

Vladan Vuletic, the Lester Wolfe Professor of Physics at MIT, says the ability to tune friction would be helpful in developing nanomachines — tiny robots built from components the size of single molecules. Vuletic says that at the nanoscale, friction may exact a greater force — for instance, creating wear and tear on tiny motors much faster than occurs at larger scales.

“There’s a big effort to understand friction and control it, because it’s one of the limiting factors for nanomachines, but there has been relatively little progress in actually controlling friction at any scale,” Vuletic says. “What is new in our system is, for the first time on the atomic scale, we can see this transition from friction to superlubricity.”

Vuletic, along with graduate students Alexei Bylinskii and Dorian Gangloff, publish their results today in the journal Science.

Watch the video.

Friction and force fields

The team simulated friction at the nanoscale by first engineering two surfaces to be placed in contact: an optical lattice, and an ion crystal.

The optical lattice was generated using two laser beams traveling in opposite directions, whose fields add up to form a sinusoidal periodic pattern in one dimension. This so-called optical lattice is similar to an egg carton, where each peak represents a maximum electric potential, while each trough represents a minimum. When atoms travel across such an electric field, they are drawn to places of minimum potential — in this case, the troughs.

Vuletic then engineered a second surface: an ion crystal — essentially, a grid of charged atoms — in order to study friction’s effects, atom by atom. To generate the ion crystal, the group used light to ionize, or charge, neutral ytterbium atoms emerging from a small heated oven, and then cooled them down with more laser light to just above absolute zero. The charged atoms can then be trapped using voltages applied to nearby metallic surfaces. Once positively charged, each atom repels each other via the so-called “Coulomb force.” The repulsion effectively keeps the atoms apart, so that they form a crystal or lattice-like surface.

The team then used the same forces that are used to trap the atoms to push and pull the ion crystal across the lattice, as well as to stretch and squeeze the ion crystal, much like an accordion, altering the spacing between its atoms.

An earthquake and a caterpillar

In general, the researchers found that when atoms in the ion crystal were regularly spaced, at intervals that matched the spacing of the optical lattice, the two surfaces experienced maximum friction, much like two complementary Lego bricks. The team observed that when atoms are spaced so that each occupies a trough in the optical lattice, when the ion crystal as a whole is dragged across the optical lattice, the atoms first tend to stick in the lattice’s troughs, bound there by their preference for the lower electric potential, as well as by the Coulomb forces that keep the atoms apart. If enough force is applied, the ion crystal suddenly slips, as the atoms collectively jump to the next trough.

“It’s like an earthquake,” Vuletic says. “There’s force building up, and then there’s suddenly a catastrophic release of energy.”

The group continued to stretch and squeeze the ion crystal to manipulate the arrangement of atoms, and discovered that if the atom spacing is mismatched from that of the optical lattice, friction between the two surfaces vanishes. In this case, the crystal tends not to stick then suddenly slip, but to move fluidly across the optical lattice, much like a caterpillar inching across the ground.

For instance, in arrangements where some atoms are in troughs while others are at peaks, and still others are somewhere in between, as the ion crystal is pulled across the optical lattice, one atom may slide down a peak a bit, releasing a bit of stress, and making it easier for a second atom to climb out of a trough — which in turn pulls a third atom along, and so on.

“What we can do is adjust at will the distance between the atoms to either be matched to the optical lattice for maximum friction, or mismatched for no friction,” Vuletic says.

Gangloff adds that the group’s technique may be useful not only for realizing nanomachines, but also for controlling proteins, molecules, and other biological components.

“In the biological domain, there are various molecules and atoms in contact with one another, sliding along like biomolecular motors, as a result of friction or lack of friction,” Gangloff says. “So this intuition for how to arrange atoms so as to minimize or maximize friction could be applied.”

Tobias Schaetz, a professor of physics at the University of Freiburg in Germany, sees the results as a “clear breakthrough” in gaining insight into “otherwise inaccessible fundamental physics.” The technique, he says, may be applied to a number of areas, from the nanoscale to the macroscale.

“The applications and related impact of their novel method propels a huge variety of research fields investigating effects relevant from raft tectonics down to biological systems and motor proteins,” says Schaetz, who was not involved in the research. “Just imagine a nanomachine where we could control friction to enhance contact for traction, or mitigate drag on demand.”

This work was funded in part by the National Science Foundation and the National Science and Engineering Research Council of Canada.


Filed Under: RF

 

Next Article

← Previous Article
Next Article →

Related Articles Read More >

Open RAN test service adds colocation capabilities
Switch operates DC to 20 GHz with 128 configurable connection states for asymmetric SerDes testing
Butler Matrix
Butler Matrix drives Wi-Fi and other phased-array antennas
Long-wire dipole antennas: still viable after more than a century

Featured Contributions

  • Overcome Open RAN test and certification challenges
  • Wireless engineers need AI to build networks
  • Why AI chips need PCIe 7.0 IP interconnects
  • circuit board timing How timing and synchronization improve 5G spectrum efficiency
  • Wi-Fi 7 and 5G for FWA need testing
More Featured Contributions

EE TECH TOOLBOX

“ee
Tech Toolbox: 5G Technology
This Tech Toolbox covers the basics of 5G technology plus a story about how engineers designed and built a prototype DSL router mostly from old cellphone parts. Download this first 5G/wired/wireless communications Tech Toolbox to learn more!

EE LEARNING CENTER

EE Learning Center
“5g
EXPAND YOUR KNOWLEDGE AND STAY CONNECTED
Get the latest info on technologies, tools and strategies for EE professionals.

Engineering Training Days

engineering
“bills
5G Technology World
  • Enews Signup
  • EE World Online
  • DesignFast
  • EDABoard Forums
  • Electro-Tech-Online Forums
  • Microcontroller Tips
  • Analogic Tips
  • Connector Tips
  • Engineer’s Garage
  • EV Engineering
  • Power Electronic Tips
  • Sensor Tips
  • Test and Measurement Tips
  • About Us
  • Contact Us
  • Advertise

Copyright © 2025 WTWH Media LLC. All Rights Reserved. The material on this site may not be reproduced, distributed, transmitted, cached or otherwise used, except with the prior written permission of WTWH Media
Privacy Policy

Search 5G Technology World